Concentrated water based densifier – hardener, which reacts with water-soluble calcium compounds and converts them to water-insoluble and acid-resistant compounds inside the concrete. This reduces the porosity of the mortars and increases their density and hardness.
Substrate preparation:
The surfaces to be treated with PLANOFINISH CH should be open porous, clean, free from loose elements, powders, salts, grease, oils, dirt and any other material that could reduce material penetration.
When applying PLANOFINISH CH to create polished floors, it is recommended to apply it after finishing the initial grinding of the surface. Recommended application after using 200 or 400 grit abrasive.
Application:
Apply PLANOFINISH CH by spraying, dissolved in 1:1 to 1:4 water, depending on the type of surface and the absorbency. In case of floor polishing, apply the material immediately after spraying, with a micro-fiber cloth evenly throughout the surface. In this case the recommended dilution is 1:2 to 1:3 with water depending on the stage of application. In any case, keep wet the surface where the PLANOFINISH CH has been applied for 15 - 20 minutes. Repeat the above procedure if required. The polishing process is continued after 30 - 60 minutes after the surface has dried, with dry diamond resin abrasives to the desired degree.
Recommendations:
Do not apply to surfaces:
Legal Notice:
The technical data and recommendations included or listed are the outcome of laboratory measurements combined with our current knowledge and expertise. All information and specifications should in any case be considered as indicative. The Company makes every effort to ensure the accuracy of the information provided herein. Product specifications are subject to change without notice and may differ from product images. Due to printing and application procedures, the colors displayed here should be considered as indicative. In particular, variations in materials, substrates and on-site application conditions are such that no warranty can be given or implied reference to the suitability of the materials for trading or use for a particular purpose and conditions of any given project. Anyone interested in using the product must ensure beforehand that the product is suitable for the intended use and in any case, the user is solely responsible for any outcomes associated with the use of product. Among other things, the Company is not responsible for any normal wear or tear from environmental or any other unsuitable conditions. We reserve the right to revise or change the data herein without prior notice. Restrictions and disclaimers apply to the extent permitted by applicable law. The Company has a Technical Support Department, which has exclusive responsibility for providing technical advice and solutions, addressing relevant issues. Requests to the Technical Support Department are addressed and answered, only in writing. For the latest and valid version of the Technical Data Sheet, the user of the material must refer to our website www.novamix.gr.
