Substrate preparation:
Cementitious substrates must be solid and free of dust, salts, grease and any other materials that could reduce adhesion. If deemed appropriate, the removal is done by mechanical means such as sandblasting, sanding with a wire brush, etc. In case of cracks as well as anchorages, clean the inside of the crack/hole with convincing air. Metal surfaces must be free of any surface oxidation - rust.
Preparation of the mix:
Before mixing the two ingredients, it is necessary to mix each ingredient separately in its respective container. Then the two components are mixed very well together, until a perfectly homogeneous mixture of grey color is created. Partial mixing of the two components is not recommended, but if required by the application, the ratio of the two components must be meticulously observed as indicated on the container labels.
Application:
As a bonding bridge between old and new concrete and for the NOVACEM CREATIVE terrazzo and micro-pebble coverings, it is applied with a brush, spatula or spraying. Apply the new layer of cementitious coating while the layer of EPO FLUID remains fresh, 1-1.5 hours.
It is applied as an anchor casting agent after mixing the material directly from the container. Fill the preform hole approximately 60% so that a small amount of resin overflows from the hole when the anchor is installed. Make sure there are no air gaps inside the hole.
As a filling material for cracks depending on the width of the crack from injectable equipment, nozzles and handguns or special equipment, as well as a trowel or spatula. In translucent cracks, precede surface plastering of one side with the epoxy paste EPO PASTE.
Recommendations:
Do not apply EPO FLUID to:
- Substrate and ambient temperatures below +5°C and above +35°C
- Relative atmospheric humidity> 80%
- Prolonged exposure to acids, bases, solvents, etc. medium and high concentrations
- Improperly prepared surfaces
- For sealing expansion joints
- In case of anchors where the diameter of the hole is not at least 3 mm larger than the anchor
- It is recommended that the application be done by a professional user and the partial mixing of the two components is the sole responsibility of the user
Cleaning:
Tools should be cleaned immediately with the solvent NOVATHINNER PU if EPO FLUID is fresh. Once hardened, cleaning can be done only by mechanical means.
Legal Notice:
The technical data and recommendations included or listed are the outcome of laboratory measurements combined with our current knowledge and expertise. All information and specifications should in any case be considered as indicative. The Company makes every effort to ensure the accuracy of the information provided herein. Product specifications are subject to change without notice and may differ from product images. Due to printing and application procedures, the colors displayed here should be considered as indicative. In particular, variations in materials, substrates and on-site application conditions are such that no warranty can be given or implied reference to the suitability of the materials for trading or use for a particular purpose and conditions of any given project. Anyone interested in using the product must ensure beforehand that the product is suitable for the intended use and in any case, the user is solely responsible for any outcomes associated with the use of product. Among other things, the Company is not responsible for any normal wear or tear from environmental or any other unsuitable conditions. We reserve the right to revise or change the data herein without prior notice. Restrictions and disclaimers apply to the extent permitted by applicable law. The Company has a Technical Support Department, which has exclusive responsibility for providing technical advice and solutions, addressing relevant issues. Requests to the Technical Support Department are addressed and answered, only in writing. For the latest and valid version of the Technical Data Sheet, the user of the material must refer to our website www.novamix.gr.
